If you’ve been looking for a fun weekend sewing project that’s both cute *and* creepy, this one is for you. This DIY Demogorgon flower bag is inspired by the iconic Stranger Things monster – and yes, those scalloped “petals” along the top are exactly what you think they are. The result is a kawaii drawstring bag that looks like it came straight from the Upside Down, and the whole thing takes just about 2 hours to make.
Best of all? No complicated techniques. If you can sew a straight line and cut a circle, you can make this.
-----
## What You’ll Need
- 0.5 meters of outer fabric** – try red velvet or black cotton for a Demogorgon vibe, or pastel floral for a softer kawaii look
- **0.5 meters of lining fabric**
- **Drawstring cord** – 150 cm long, 3 cm wide
- **Basic sewing kit:** scissors, pins, sewing machine, bodkin (or safety pin)
- **Printable pattern template** *(optional – or use the measurements below to draft your own)*
-----
## Cutting Guide
Cut **one piece each** of outer fabric and lining to these dimensions:
- **Width:** 54 cm
- **Height:** 32 cm
- **Top edge:** scalloped – 10 cm diameter circles, spaced 0.5 cm apart
- **Casing channel:** 2 cm from the top of the straight edge (marked on the body of the bag)
> **Tip:** The scalloped edge is on the TOP of the fabric panel, not the bottom. The circles are approximately 5 per panel depending on spacing.
-----
## Step-by-Step Tutorial
### Step 1 – Cut Your Fabric
Cut both your outer fabric and lining to the dimensions above, including the scalloped top edge. Use a circular template (a glass or jar works perfectly) to trace your circles before cutting.
### Step 2 – Sew Outer and Lining Together
Place your outer fabric and lining **right sides together**.
Before you sew:
- Leave a **5 cm gap** on one side seam of the lining – this is your turning gap
- Leave the **drawstring channel opening** on the outer fabric **unsewn** (this is where the cord exits)
- Fully sew the lining seams closed everywhere else
### Step 3 – Sew the Scalloped Curves
Sew around all the scalloped “petal” curves along the top. Use about a **6 mm seam allowance** for the curves.
After sewing, **trim away the excess fabric** close to your stitching line – but not too close! You need just enough seam allowance left to sit smooth when turned.
> **Key tip for the curves:** Any curve with a tight arc (the “valley” between two circles especially) needs small **clips** snipped into the seam allowance before turning. Cut almost to the stitching line – not through it. This is what gives you those smooth, round petal edges without puckering. Take your time here.
### Step 4 – Turn and Topstitch
Sew the scalloped top edges of the outer fabric and lining together, then **turn the whole bag right side out through the gap** you left in the lining.
Once turned, press everything flat and **topstitch the gap closed**. You can also topstitch along the scalloped edge for a clean, professional finish.
### Step 5 – Create the Drawstring Channel
Sew **two parallel rows of stitching** across the bag at the drawstring channel position (2 cm from the top straight edge). These two lines of stitching create the channel your cord slides through.
### Step 6 – Thread the Cord
Cut your drawstring cord to **150 cm**, attach a bodkin or safety pin to one end, and thread it all the way through the channel. Knot or knot-and-bead the ends to finish.
**Done!** 🌸
-----
## Tips for Getting the Best Results
**The scallops are the trickiest part** – but once you nail them, the rest is very straightforward. Here’s what to remember:
- **Clip generously** into the concave curves (the “valleys” between the circles). The more clips, the smoother your finished edge.
- **Sew slowly around the curves.** Lift your presser foot every few centimetres to pivot and keep your stitching line smooth.
- **Press as you go.** An iron makes a massive difference to how professional the finished bag looks.
- **For the Demogorgon look:** choose a dark red, burgundy, or textured black fabric for the outer layer. A slightly stiff fabric (like cotton canvas or velvet) holds the petal shape beautifully.
-----
## Finished Size
This bag finishes at approximately **26 × 30 cm** (not including the petal tops), which is a great everyday pouch or project bag size.
-----
## Make It Yours
Once you have the basic pattern down, the customisation options are endless:
- **Halloween version:** black fabric with orange lining
- **Kawaii pastel version:** mint or lilac with a white cord
- **Cottagecore version:** ditsy floral outer with a cream linen lining
- **Full Demogorgon cosplay prop:** dark red velvet + black fray detail on the petal tips
-----
## Want the Pattern PDF?
If you’d like to skip the drafting and start sewing right away, the **CuteSewing Flower Drawstring Bag PDF pattern** includes:
- Full-size printable templates (A4 and A3)
- All measurements included
- Suitable for total beginners
👉 **[Get the pattern here →]** *(insert product link)*
-----
*Happy sewing! If you make this bag, tag us on Instagram or Pinterest – we’d love to see your Demogorgon come to life. 🖤*
-----
**Tags:** beginner sewing project, drawstring bag tutorial, Stranger Things DIY, Demogorgon bag, flower bag pattern, kawaii sewing, easy sewing projects, scalloped bag tutorial, DIY fabric bag